40935 Media Handler MDH: Drum vacuum timeout: Failed to exceed vacuum threshold (<Threshold> kPa) within <Timeout> sec (only reached <ActualValue> kPa). [<I/O name>] Fail to generate drum vacuum above threshold within the timeout. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Media not loaded on drum properly. Leak in the drum vacuum system. Drum vacuum pump failure. Threshold - This is the threshold value that was not reached. Timeout - This is the amount of time allowed to reach the threshold. ActualValue - This is the actual value reached after the timeout. I/O name - This is the standard firmware name of the sensor. 28-Sep-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:33 2008 PST